A Lattice Approach to Image Segmentation

After a formal definition of segmentation as the largest partition of the space according to a criterion σ and a function f, the notion of a morphological connection is reminded. It is used as an input to a central theorem of the paper (Theorem 8), that identifies segmentation with the connections that are based on connective criteria. Just as connections, the segmentations can then be regrouped by suprema and infima. The generality of the theorem makes it valid for functions from any space to any other one. Two propositions make precise the AND and OR combinations of connective criteria. The soundness of the approach is demonstrated by listing a series of segmentation techniques. One considers first the cases when the segmentation under study does not involve initial seeds. Various modes of regularity are discussed, which all derive from Lipschitz functions. A second category of examples involves the presence of seeds around which the partition of the space is organized. An overall proposition shows that these examples are a matter for the central theorem. Watershed and jump connection based segmentations illustrate this type of situation. The third and last category of examples deals with cases when the segmentation occurs in an indirect space, such as an histogram, and is then projected back on the actual space under study. The relationships between filtering and segmentation are then investigated. A theoretical chapter introduces and studies the two notions of a pulse opening and of a connected operator. The conditions under which a family of pulse openings can yield a connected filter are clarified. The ability of segmentations to generate pyramids, or hierarchies, is analyzed. A distinction is made between weak hierarchies where the partitions increase when going up in the pyramid, and the strong hierarchies where the various levels are structured as semi-groups, and particularly as granulometric semi-groups. The last section is based on one example, and goes back over the controversy about “lattice” versus “functional” optimization. The problem is now tackled via a case of colour segmentation, where the saturation serves as a cursor between luminance and hue. The emphasis is put on the difficulty of grouping the various necessary optimizations into a single one.     

叠前地震数据优化处理技术分析

由于叠前时间偏移成像是在叠前数据上进行的，因此对数据的质量要求较高。针对这一问题进行了数据优化处理技术研究，研究的基础资料是胜利油田渤深6区块的三维地震数据，首先对资料的质量进行了分析一由于是拼接资料，因此存在着能量不均衡、覆盖次数不均匀、坡形不一致以及各类干扰发育等问题；然后针对这些问题研究了时间-空间域内分频随机噪声衰减、频率一空间域相干噪声衰减、波形匹配处理和数据拟合三维随机噪声衰减等4种处理方法，分别取得了很好的处理效果；在对实际资料进行数据优化处理时，根据资料的特点采用了合适的组合方式，处理后资料的品质得到了较大提高，相干噪声、随机噪声得到了有效衰减，波形一致性得到了恢复，中、深层有效频率和有效能量得到了加强。     

一类Schrdinger方程组解的爆破

本文研究一类Schrodinger方程组解的爆破行为,在Y.Tsutsumi等(1998)文的基础上对非线性项作了修改,并用变分的方法得到了解在有限时间内爆破的一个充分条件。     

Taxometrics in Psychopathology Research: An Introduction to Some of the Procedures and Related Methodological Issues.

This article introduces a special section on the use of taxometrics to examine the categorical versus the dimensional structure of various forms of psychopathology. Paving the way into the special section, this introduction briefly describes 3 taxometric methods--mean above minus below a sliding cut (MAMBAC), maximum covariation (MAXCOV), and maximum eigenvalue (MAXEIG)--and discusses possible threats to statistical conclusion validity that often emerge when such techniques are applied in psychopathology research. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Monte Carlo simulation of gas phase polymerization of 1,3‐butadiene. Part II: Kinetics optimization and confirmation

Studies on the deactivations and initiations of gas phase polymerizations of 1,3‐butadiene have been achieved by Monte Carlo simulation. Initiation and deactivation control the reaction before and after the peak of the polymerization rate, respectively. The influence of polymerization temperature has been studied. Monte Carlo modeling of polymerization kinetics and mechanism was confirmed by the agreement of experimental data and simulation results of polymerizations run with a temporary evacuation of monomer. The balance of catalysts and active chains is established by both initiation and chain transfer reactions with cocatalyst, which causes a ‘pseudo‐stability’ stage. © 2003 Society of Chemical Industry     

Quality of Service in VoIP Communication

The focus of this paper lies in the practical aspects of voice over IP communication. VoIP configurations in the H.323 standard will be presented briefly. Following that, the fundamental protocol procedure of H.323 communication will be briefly explained. A further part of the paper will address the subject QoS (quality of service), and present the common measurement methods used in QoS. Results gained from experiments conducted in a VoIP environment will then follow. The investigations concentrate primarily on the load behavior of voice packets in relation to important parameters of this service. The results obtained are presented and evaluated in diagrams. The paper concludes with a summary.     

"通信原理"课程教学改革探索

针对我院省重点专业“电子信息工程”的必修主干专业基础课程。“通信原理”教学中存在的不利于培养和提高学生分析问题、解决问题的能力的因素，从课程的教学内容、教学手段等方面论述了课程改革的基本构想，并对课程的实践环节——设计性实验的改革进行了探讨。     

A stochastic model for localized disturbances and its applications

A stochastic model for local disturbances, particularly for a temporal harmonic with random modulations in amplitude and/or phase, is proposed in this paper. Results for the second moment responses of a linear single-degree-of-freedom system to this type of stochastic loading demonstrate a significant change in response characteristics due to a small uncertainty. A local phenomenon may last much longer and resonance may be smeared to a broad range. Integrated with wavelet transform, the proposed approach may be used to model a random process with non-stationary frequency content. Especially, it can be effectively used for Monte Carlo simulation to generate large size of samples that have similar characteristics in time and frequency domains as a pre-selected mother sample has. The technique has a great potential for the case where uncertainty study is warranted but the available samples are limited.     

PZT陶瓷的断裂分析

与有限元法相比,无网格法由于只需节点不用单元而在压电分析中具有优越性。采用一个简单的包含有极化反转及电饱和影响的锆钛酸铅系压电陶瓷(PZT)的本构模型,以局部J积分作为断裂准则,应用再生核点法这一无网格数值法导出了作用电场与断裂载荷的关系曲线,该曲线的趋势与Park[1]的实验观察现象一致。计算程序采用面向对象方法实现。